About bprietoclv

bprietoclv · 10-07-2014

I have configured my 877W router with two SSIDs, one for work and the other one for guest access and both of them works fine, but when I try to connect a wired computer, which I'd like to use guest ip range, none of the fastethernet ports seems to w...

bprietoclv · 04-30-2013

Good afternoon,Probably this is a trivial question but I have not found any response to it. What I would like is to set my cisco 877W rotuer up in order to act as a DNS server which forwards DNS queries following these simple rules: 1.- If the na...

bprietoclv · 05-11-2012

Good morning,I am Rafael Azpiroz from IBeria Network Department. I am writing to be given some support related to a issue that I am having. The fact is that I am trying to give connectivity between two companies that are connected to mine through the...

bprietoclv · 09-12-2011

Good morning,I am trying to set a Cisco 887VA router up for a ADSL Internet connection by Telecom Italia. I have been given the following IP parameters:LAN IP Address: 85.36.247.40, Network mask: 255.255.255.248.Default gateway: 85.36.247.41.Point-t...

bprietoclv · 10-09-2014

That was the point. Change to advipservices. Thank you!!!

bprietoclv · 10-08-2014

Thank you so much Michael.I will try to contact my reseller in order to get the IOS and move from advsecurity to advipservices. Meanwhile I will try to swap vlans 101 and 102 just to see if I can enable the one that I need on the wired ports. I will ...

bprietoclv · 10-08-2014

Same error:router(config)#vlan 102Vlan can not be added. Maximum number of 2 vlan(s) in the database.I do not know why I can configure VLAN 101 instead of VLAN 102 if both of them has the same configuration. Maybe because, as show in the show vlans c...

bprietoclv · 10-08-2014

What can see is that there is nothing related to vlan 102 on the output of show vlan-switch. In fact I have tried to configure vlan 101 (which is not the one that I want to configure) on the FastEthernet0 and it works and I can get dynamic IP from th...

bprietoclv · 10-08-2014

If I try to assign vlan 102, which is the one that I want, I get the following error:router(config)#int fa0router(config-if)#switchport mode access router(config-if)#switchport access vlan 102Vlan can not be added. Maximum number of 2 vlan(s) in the ...

Member Since	‎06-16-2008 10:31 PM
Date Last Visited	‎09-07-2018 12:56 AM
Posts	11

User Statistics

User Activity

Wired and wireless access within a multiple SSID 887W router

Setting up DNS forwarding in Cisco router

Cisco VPN 3030: connectivity between L2Ls

Cisco 887VA Internet settings for Telecom Italia ADSL

That was the point. Change to

Thank you so much Michael.I

Same error:router(config)

What can see is that there is

If I try to assign vlan 102,