Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a way to send the actual System Tempurature value to an SNMP (CNA health monitor) host not just temp ok?
I have traps set but want to see the temp now not when it hits the thershold. ver 15.1
Thanks!
I have a mixed stack - 3750E with ios c3750e-universalk9 and a 3750V2 with ios c3750-ipbasek9.Whenever I try to archeive download-sw to either switch I get a message :Error: The image in the archive which would be used to upgradeError: system number...
We're running LMS 3.1. Whenever I try to telnet to any device I get a message "Application Not Found". What application is it trying to open and how do I change it?
I've been experiencing drops from the server network to clients intermittently.doing a sh cef drop on the L3 switch that the servers are connected to the Encap_fail counters increase about 10 per second. Do I have a cef problem?I'm on version 12.2(1...
If a 3750E switch that is only doing layer 2 and not layer 3 receives a packet from a server that's larger than the 1514 byte packet, say 4098, what does it do with the large packet?
The mac entries are not stable. Even after pinging its IP successfully, the MAC address was not in the table:Error: Destination Mac address not found. Layer2 trace aborted.
You said the switch cannot fragment frames between LANS of differing MTU size. This particular setup the traffic is between a Citrix and SQL server on the same 3750E switch and the MTU size on the switch is default (1500). It appears the SQL server...
