Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I was wondering if anyone has ever implemented the Cat 3110X/G in an IBM BladeCenterH chassis? On the Cisco design guide (http://www.cisco.com/en/US/prod/collateral/switches/ps6746/ps8741/ps8761/design_guide_c07-455528.html), it stated that there...
Hi, I'm trying to set up single cloud DMVPN in Dynamips but having some really frustrating issues. I could set up dual cloud without any problems. Here's some background info:Head End Routers:- Dual head end, connected on LAN segment- Running EIGRP o...
Hi Experts!I'm wondering if the FastEthernet mgmt port on the ASA 5540 can be configured as routed port? Or is it purely for out-of-band management?Thanks
Hi,Based on the data sheet and the config guide, the Cisco ASA 5500 series supports multiple VLANs. I can only assume that it also support 802.1Q trunk to carry multiple VLANs across the same physical link.What I'm wondering is whether the appliance ...
Hi...I have not used NAT on Cisco routers for a while (last time was on IOS 12.1), and I noticed that the command above (ip virtual-reassembly) is enabled by default when NAT is configured on an interface (starting from 12.3 something). My question i...
Thanks for your reply. I'm quite aware of what the SRND said, which you have quoted very nicely above. Having said that, the set up that I need to do is multiple spoke-to-spoke clouds.Anyway, I have actually solved my own issue. As it turns out, an ...
I'm pretty sure that WIC-2T can support 8Mbps with the use of V.35 cable. However, you can only use 1 port. If you connect both serial ports, then you'll only get 4Mbps on each port. From memory, WIC-1T can support 4Mbps, as long as you use V.35 cabl...
So, if I understand you correctly, your set up is "box" configurations with trunk between the two cores, trunk between the two 3524s, and then 1 uplink from each 3524 to one of the cores. In this case, it's quite normal for both uplinks to core to be...
The reason why you don't see hop-by-hop MTU size is because the MTU size used at each hop is the same. Any hosts conforming to Path MTU discovery standard would basically attempt to determine the max MTU size that can be transmitted end-to-end withou...
