Hello to all, is possible that packet could no be marked inbound fa0/0For example(R1)s0/0/0 <--> s0/0/0 (R2)(R1)s0/1/0 <--> s0/1/0 (R2)Two routers connected through two serial interface in load sharing per packet.this is the conf for R2:class-map mat...
Hello to all, I have this problem:2 switches:Switch A 48 port in RAPID-PVST+Switch B 24 port in 802.1dSwitch B is connected to switch A through port 1 in trunkThere are VLAN 2,4 and 8 in Switch A and only VLAN 2,8 in Switch BThe question is: How is ...
Is there any information or block diagram about how is thesignal routed or relationship between controller <-> serial , howthe error control works in timeslots mode or unframed, for example,someone told me that setting it in unframed mode, the er...
Hello to all, I'm having problems in understanding how bgp choose one route and discard other based in its SOO, for examplesuppose this examplelook at the network diagram in the link:Figure 1 Network Diagram for SoO Example(BGP per Neighbor SoO Confi...
Two routers connected through two serial interface in load sharing per packet.Sorry I made a mistake when cutting and pasting :)---------WRONG------------R3class-map match-all DSCP-AF33match ip dscp af33policy-map DSCP-AF33class DSCP-AF33interface Se...
Thanks for your feedback and IOS recommendation; if i put the keepalives to default, I could not sense the problems in the interface, setting to default you will see the problem as a eigrp flap because of retry timeout, so for the analysis I'll prefe...
The traffic is more and less 900Kbps max, the E1 interface is at 50%, here is a sh interface of the PA-E3 that have the same problems of the E1: Note: The drops you see are probably for the delay between the carrier transitions and the "hole" created...