Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Everyone ,We are having issue to join the cisco 2702i AP to our new 9800 WLC . After collecting the debug IP and debug mac address from the 9800 , we found out the 9800 was the one drop the dtls connection with below reason : 2024/06/24 12:38:28...
The LED light of 3802 AP is off after registered with 9800 WLC . But the 3802 access point is still working perfectly in providing the wireless connection to the end device . We have factory-reset the AP and issue remain the same after the AP regist...
Hi ,
I am having issue here with the client which are connected through 2702 AP by enabling 802.1x will not able to telnet/SSH to others devices . But the client connected through 3802 AP with same setting will works perfectly .
But when we removed...
Hi Guy , I am trying to register UCM-PAK with PAK code sent by Cisco , but i have ran out of idea what should i pasted on the page no. 2 (see attached ppt) , The page is asking "Paste the content of the License Request provided by Enterprise License ...
Hi Guy ,Good day !Just would like to see some advice regarding this issue . I am setting up the PLAR on my call manager (version 10.5) for several analog phone (connected through ATA 190 and then connected to switch) which are placed in production fl...
Dear Marce ,thanks for your sharing . Below is the output from the Wireless Config Analyzer Express using show tech wireless output. But i do suspecting the WLC is hitting the bug CSCwi16509 as i saw two entries on WLC with same IP address , but dif...
Dear Leo ,thanks for your sharing . But there is no certificate related error was logged on the debug . In fact , the AP is always stuck on the image downloading state and keep repeating the same cycle again after reload .
Dear Jagan ,Yup , this LED state setting has been verified , the LED state is showing enabled and we can see the LED is blinking when we reloading the AP , but the LED light will just goes off after it registered with WLC successfully . We have tried...
Dear Jerome ,Yup , LED state on APs has been verified in CLI and GUI , both are showing enabled already . But issue remain the same . Even we tried to disabled and re-enabled the LED state on few APs , issue remain the same .
Hi rrudling ,
Cisco 5520 WLC , issue was found on 8.2.166.0 . We upgraded to 8.2.170 and 8.3.143 (cisco recommended version ) , issue remain the same .
Issue reported :
client connected to 2702 AP cannot telnet / SSH to core switch as well as oth...
