Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm setting up a new ISDN link. The link thous the NT Box shows the line as active does not come up. I have checked with local telco and they've confirmed the line as being OK. The show isdn status output is as follow:003R#show isdn statusISDN BRI3/1...
Hi,This is my problem,i have set a VOIP networkin a Bank,this is how it work,i have a central gatekeeper at the head office which controls all the branch gateway.At the headoffice i have a PRI connection from the gakeeper to a Nortel PBX,at the bran...
Coul anyone of you direct me to some information concerning network interface cards/network modules,an analysis of these module/interface cards would be okay.
Hi,I have a 2948 switch with an IOS that i am fing it difficult to use,most commands are not the conventional ones,Could any of you give some guidance on how i can do this upgrade?
I have a PRI card connected to a PBX. Am able to make outgoing calls from internal extensions but external calls are not being forwarded through the PRI card. The setup has been OK till last week.This is the config on the card:interface Serial0/3/0:1...
Hi,Find the output on the gatekeeper based on the above:VOIP#show isdn statusGlobal ISDN Switchtype = primary-net5ISDN Serial0/3/0:15 interface ******* Network side configuration ******* dsl 0, interface ISDN Switchtype = primary-net5 ...
Hi am a bit far i cant run the above command but mayy be you could give your email address so a ica send you a copy of my running config so you can highlight areas that need some correction.my address is nickolaskoiser@gmail.comSend me your address s...
Am using a cisco 2811 router with pstn lines terminated to its FXO ports,9 fxo lines are terminated to the router.Am in Kenya.Caller id?No idea what this is.Please help.
The router has been configured with the command line con 0 exec-timeout 5 0 logging synchronous no exec autohangupThe 'no exec' command is where the problem comes in,it has no ip address on any of its ethernet interfaces.Please help me...
