Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,
I have a HA pair of Prime Infrastructure, recently i tried to change the role of Prime and secondary units for the sake of checking its working. As a result the Primary unit became secondary and the secondary unit became Primary. Some pr...
Hi Guys,
I need some information from the experts here, i am in a process of installing the Cisco MSE but when i go to the down load i see the new release 10.x.x named CMX. I need to understand that is the new model re-branded with this name of CMX o...
Hi Piotr,
You have to make sure everything which makes up your WLAN setup is integrated to your Prime Infrastructure. This means Prime should know the following.
1. All the switches in the network
2. All the wireless controller in the network
3. Al...
Hi ,
Can you answer few of the below/
After the reboot are you able to ping the IP address of Prime? You should be able to access your Prime infrastructure atleast via it's IP address. Haven't you generated the csr from the Prime device it self?
Re...
Hi Vasco,
Thanks for your reply yes the final picture is to integrate CMX with Prime3.0 which is also a fresh installation. So am I going to loose any functionality if i go for CMX 10.2 rather than MSE8.0. (It's going to be a VM setup).
Regards,
