Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a bunch of these messages in my log on my 3850 switch. How should I troubleshoot this?
*Aug 10 09:20:40.141: *%SOCKET-2-SOCK_RECV_ERR:Switch 1 R0/0: wcm: Error parsing from CAPWAP socket*Aug 10 09:20:45.327: *%SOCKET-2-SOCK_RECV_ERR:Switch 1 ...
Where do I tune the RRM based on site survey software settings?
In the site planner report shows: (How would I tune RRM to these settings?)
Coverage Requirement: Voice + Data
Signal Strength Min
-67.0 dBm
Signal-to-noise Ratio Min
20.0 dB
D...
I need to factory default a pair of 4500 switches in VSS mode. This is how I plan to do it. 1. on switch 1 execute redundancy force-switchover2. write erase on the switch 2 and reload3. this should failover to switch 14. write erase in switch 1Is t...
I need to factory default a pair of 4500 switches in VSS mode. This is how I plan to do it. 1. on switch 1 execute redundancy force-switchover2. write erase on the switch 2 and reload3. this should failover to switch 14. write erase in switch 1Is t...
Our ISP is sending us a default route.We are also originating a default route into our network via ospf default information originate. The problem we are running into is that when we lose our ISP, but we do not lose our peering, we no longer receive ...
WLC: 5520
WAP: 3802i
Software Version: 8.5.131.0
The software was upgraded about 2 weeks ago. No other changes have been made. The access points are local and connected to a 3850 switch via the mGig ports. I've seen this message before with the 8.2...
I was looking at the uc540's. But I am not clear on what I need on my end. I have an empty new contruction office with a no pots or pbx.Besides the uc540 and internet access what else do I need. Do I need to contract with a sip or voip provider? How ...
I modified the acl to allow ranges and now I get nothing at all. F0/0Ip nat insideIp policy route-map VOICE_TRAFFICAtm 0/3/0.38 Ip nat outAtm 0/3/0.100Ip nat outaccess-list 110 permit ip 10.1.0.0 0.0.255.255 any(ideally there would be a subnet for d...
