Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys, I am configuring 2x 3560's to work with VmWare. in gig0/1 i have vmnic0/vmnic1 (service console) on both switches, now normally i would have them on a port-channel but when doing it over two 3560's im not sure the best way to do this? We hav...
Hi Guys, I have purchased a 1041N for our office and didnt realise how different they are from other AP's i have used before! Please could someone give me a hand configuring this. Basically we want 2 SSID's one for guests i have managed to set this u...
Hi Guys, Just put the new firmware on our phone system 7.4.9c but none of the phones are upgrading when rebooted they currently all run 7.4.6 I have checked the config and have the following: tftp-server flash:/phones/50x-30x/spa50x-30x-7-4-8a.bintft...
Hi Guys,We have just installed a Sonicwall on our network and users want to use the VPN and soft phone from home.when we take laptops home and connect over VPN the IP Communicator just says registering all the time and nothing happens do i need to co...
Hi All,has anyone setup oak call logger with the UC560? or any of the UC500 range? i need to know what i need to do in order to get this working it is rather urgent but the lead time for Oak to fix it is 2 weeks which is far too long.your help would ...
Is there anything else that we can do? Or would we just leave them as trunk ports and use vmware to manage the nics? Im guessing that with Vmware it will know about the second nic and this will stop any network loops etc?
i have managed to figure our that i cannot access the cisco uc560 at all over the VPN so i think this is causing my issues! i have logged the call with sonicwall hopefully they will have an answer as to why i can access all the network other than swi...
Hi James,the Sonicwall that we are using does have the virtual network adapter, and is over IPSec.on the phone system do i need to assign the phone to the mac address of the virtual adapter or of the physical adapter?RegardsSteve
but users are using a VPN so i shouldnt need to open any ports as it is basically on the network. wouldnt this be something to do with the route between 10.1.1.0 network and our 192.168.4.0 network?
