Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Not sure why its not working but what happened is I had my cisco ASA 5506 die and I ordered a replacement. I restored the config but the only thing that is not working is the Guest wifi network. The regular network for internal works fine.I am ...
Hello,
I had a static IP assigned to me by my isp. Which is fine but now I have an ip range of 5 address's i would to add the second static IP and point the type of traffic coming on that to a specific internal server.
Do I need to create another int...
Hello,
I have a user that is using a pptp vpn internal connection to an external server. Does the firewall scan this type of traffic and therefore slow it down
Thanks in advance
Hello,
I have been trying to change the dhcp ip to static ip. I did the following on adsm
When to interfaces changed from DHCP and put in the static ip of
69.71.170.xx9
mask 255.255.255.252
Then added a static route under routing
IP: 0.0.0.0
Mask: 0...
It is a range that is supplies. I will put in the running config but i will blank out the ips. I hope by changing the ip's its not to confusing : Saved:: Serial Number:: Hardware: ASA5506, 4096 MB RAM, CPU Atom C2000 series 1250 MHz, 1 CPU (4 cores)!...
OK what I tried is I added a public server, and then I added a rule in acl and it still doesn't work. Here is my config
: Saved
:
: Serial Number: JAD1929028T
: Hardware: ASA5506, 4096 MB RAM, CPU Atom C2000 series 1250 MHz, 1 CPU (4 cores)
:...
Sure here you it is
: Saved
:
: Serial Number: JAD1929028T
: Hardware: ASA5506, 4096 MB RAM, CPU Atom C2000 series 1250 MHz, 1 CPU (4 cores)
:
ASA Version 9.4(1)
!
hostname FW-LNALaval
enable password bgThEbkkouozdXwk encrypted
names
!
interf...
I made a mistake in saying the answer is correct.
I am still not getting it to work.
Please see attached snapshots of what i have currently working with https
How do i add a second, I have tried simply using what is currently there and its nor workin...
