Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm running CME/CUE 7.0 and have calling inbound and outbound via a sip trunk to an ITSP which works fine. I recently instaled a AIM-CUE module which is running 7.0.6 code and it works fine from internal DN's. However, when callers from the outide ...
I'm trying to figure out why a simple site setup won't route or progress call's correctly. This is an issue I've never experienced before so I'm a bit stumped as to why it's not working. I feel as if I've debugged everything I can but can't see the...
Hi everyone, I'm troubleshooting a small issue and I can't seem to wrap my head around how this specific scenrio is supposed to be configured.I'm tryign to figure out how to get one Cisco 2811 ISR with multiple 2MFT-T1 cards in it to pass calls betwe...
Hi everyone,I have a question that's been knocking me down since last night. Typically I can troubleshoot anything but I'm feeling a serious mental block right now. I have 4 CIPC phones registered to CUCM, each acting as a seperate PSTN phone. CUC...
Hi everyone,I am very new to configuring the ASA particulary after the change to how NAT is implemented. What I am trying to accomplish logically seems fairly simple, yet I cannot get it to work. I have a Synology NAS at home that I am trying to re...
Find the answer after walking away for a bit. I ran debug ccsip calls and was seeing a disconnect cause code of 302. Googled the code which brought me back to these forums and found the answer. I had to issue the following command under voice serv...
I think there were a couple of small errors in your reply Alex but correct me if I'm wrong.Here is what I have configured on the PSTN Router:dial-peer voice 101 pots destination-pattern 831.... port 0/0/0:23 prefix 831!dial-peer voice 322 pots destin...
Awesome, thanks Chris. As soon as I read your post I had one of those "wait, what" moments. Meaning, I already had partitions/css's setup for my entire setup.. However, I set the hard disk on my PSTN CUCM to Non-persistant mode and it's been runni...
