Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Migrating from C5548UP to C93180YC-FX. I have fcoe and npiv features enabled. I am trying to configure a VFC interface with "switchport mode E" and obtain error "vfc6: (error) configuration of this port mode not allowed"Configuration is as follow...
We are looking into installing DCNM7.2 and in the prerequisites it refers to requiring two port groups: "The host machine is installed with ESXi and two port groups are created—one for EFM network and the other for DCNM Management network."
What is ...
Upgrading a VDI environment that uses existing context with SSL certs/keys by creating a new context with the new VDI servers. I have successfully exported all certs/keys out of existing context; however, upon importing into newly created context, t...
I have configured such that switch 1 always be the active role. Last night, Switch 1 lost power; Switch 2 became active, however, when power restored to Switch 1, it came up as Standby and did not transition to Active. Below are the details as conf...
I have a Multilink configuration which, after about 1 week, both member T1's start showing numerous errors. A simple reboot of the router resolves the problems.On both central and remote routers, the T1's are configured to look at the provider line ...
Found my answer in the 9.3(x) config guide, a single line buried in the fiber channel interface config steps that states "vFC interfaces support only F mode". Not mentioned anywhere else, though the command is available on the switch just with the ...
I have the same problem. This was originally deployed many versions ago and was originally guest OS of "other linux 32bit" along with the Flexible network adapter. Now, after numerous ACS upgrades/patches, along with the numerous VM environment upg...
That's exactly what it was. I am in the habit of the older "write mem" and need to change to the "copy run start". Thanks for the quick responses everyone.
A) Not sure we are on the same page. Being a virtual switch - the config is synced between the switches. Switch 2 will have a copy of the running config from Switch 1. Once the stand-alone switches are converted to virtual, the only thing in the ...
