Hi,Which IOS for ME 3600X switch better suits production deployment (more features, less known/unknown(by TAC) bugs, etc.) ? What are key differences?The choice is between:15.3-1.S15.2-4.S2wbr,Alex---DAO21-RIPE
Hello!Is there any convenient way to get the summary for the Rx/Tx power levels (dBm) for all DOM enabled optical interfaces on the system, like "show interfaces transceiver" that is available on non-XR IOS ?ThanksWBR, Alex.
Hello.Assume we have:#sh class-map Class Map match-all AnyNonIP (id 1) Match access-group name AnyNonIP Class Map match-any class-default (id 0) Match anyand:#sh access-lists AnyNonIPExtended MAC access list AnyNonIP permit any anyAssume then...
Hello.I have Cisco Cat 2960G (IOS 12.2(50)SE3, lanbase image). Trying to limit available bandwith on port for 250 Mbps. The actual speed does not raises higher than 200 Mbps. Any ideas with queue set ?sw1#show running-config interface gigabitEthernet...
Okay, I understand this. But I mean, will be the traffic, that goes through the interface with service-policy TEST1 in and service-policy TEST2 in treated differently?
Since you've noted bandwidth peaks about about 200 Mbps, does it do so routinely? If so, the share of buffer allocations might be insufficient. I see your threshold settings have already been adjusted much larger than the defaults. I see you've al...
Hiabout utilization - look through the link: http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a00804cef15.shtmlAlso high IP Input usage could mean some sort of DoS/DDoS attack on ip addresses that are on 4500 (svi's, route...
JosephDoherty написал(а):See "These values are not exact because the hardware adjusts the line rate in increments of six." from: http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_50_se/configuration/guide/swqos.html#wp12...
Perhaps? this link could guide you to this:http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/31sg/configuration/guide/mib_supt.htmlRegards, Alex