Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,
We have Cisco VG 350 we have configured with SCCP protocol with CUCM 11.5 but we are not getting it registered with cucm.
Note: We have not yet connected and configured analog FXS ports in it.
Please suggest if there is any command t...
Hello,
Call Flow is IP Phone-->CUCM(10.5)-->SIP Trunk-->VG-->CVP
I am dialing a number 9221 from IP Phone DN: 1111. 9221 Route Pattern is available in CUCM10.5 & it is directed towards VG (Via SIP Trunk)
CCSIP messages shows BYE sent from VG...
Hello All,
My setup is simple. Please find below call flow,
User calls board number.
Board Number is associated with CTI RP
CTI RP is forwarded to Voice Mail.
Call Handler is configured with same Board Number with standard gree...
Hello All,
Recently i have migrated CCX cluster from 8.6 to 11.5.
In CCX 8.6 version customer was able to customize Live data(threshold value) on supervisor desktop . i.e No of waiting calls, Longest call in queue etc.
After migration of CCX 8.6 ...
Hi bijo,
Thank You for your prompt reply and support.
I have configured Dial-peer in the VG 350 and found Voice-port 2/0/0 is registered with my CUCM. PFA
Below are my few queries,
Do i have to manually configure pots Dial-Peer for every analog...
Hi bijo,
Please find attached show run and below required output. I have configured of the port 2/0/0 in cucm.
=============================================================================================
sh sccpSCCP Admin State: UPGateway Local In...
I have followed the document and i found Gateway is register with CUCM but on CUCM side it is still not showing register status.
Note: I have configured FXS port in the router but still have not connected analog phone to it as i have no Cable to c...
