Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The IBM P7 blade server is connected to the Nexus 5K via FCOE port-channel (2x10G CNA), then the NX 5K uplink to the 6509 via ethernet port-channel (4x10G). Per 5.02 NXOS configuration guide, only physical FC ports can be linked ports. Please advise ...
The router is connected to two OSPF neighbors via a flat vlan. Each neighbor inject default-route (default originate). Thus, it receives the default-route from each of its neighbor. How can I change the OSPF metric to make one default-route is less f...
Per doc, the Airespace support multiple vlans and 802.1D, but it does not specify the trunk encapsulation for WC port 1 or 2. So what would be the switchport configuration for Cisco switch, trunk or access? We try to deploy 45 AP with multiple WLAN (...
I want to set up full redundancy environment in the DMZ for Web servers with two CSS 11050, two PIXs, and two 4506 switches. There is trunking between the 4506. One CSS connects (uplink) to one of the 4506. Based on the Private Vlan config guideline...
Riccardo,Very good info I am much appreciated. One last question about this regular expression. ip as-path access-list 10 permit ^100_[0-9]*$Please interpret it if you may.Thanks,Andrew Tran
To reduce the BGP route table due to cpu/memory resources, I'd like to allow prefixes ORIGINATED in specific ASNsip as-path access-list 10 permit ^100$ip as-path access-list 10 permit ^200$The above as-path allows prefixes ORIGINATED in AS 100 and AS...
Thanks for your reply !I have one last question in regard to vsan trunking via TE san port-channel. Can one san port channel (vsan trunking) carries multiple vsans for multiple vfc? See config below for clarification.vsan database vsan 111 interface...
Hello Vincent,We need the port tracking feature, cause there is only one ethernet port-channel uplink to the 6509 via SPT Layer-2. The FCOE is still up when the uplink goes down (6509 failed), then the P7 will continue to send traffic without faill-o...
Sorry I did not provide the details. All 15 sites are OSPF-neighbored via a Metro Fiber flat vlan. Two sites inject the defaut-orginate into OSPF. I want load sharing the outbound for internet traffic between the two sites. How can I manipulate the m...
