Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an unusual situation, we use webvpn and one specific site doing a specific task makes our concentrator stop talking via ip out any of it's ethernet ports. You can console in and it shows nothing, everything says up, no crash log, it doesn't r...
I am running ANI Server 4.2, on Common Server 2.2 and RME 3.5. Trying to clean up ANI database I decided to run the reinitdb.pl script, now my discovery doesn't go past my seed files. All of the configuration looks good (seed files, snmp setup), what...
Does anyone have a solution to post IPM reports to a intranet web site? Besides the fact the reports don't print well we would like to post them to a web site but I am not finding a way to transfer them to a web site.Any ideas would be greatly appre...
I want to load IPM 2.4 on a server with 2000 professional and service pak 3, it only recommends service pak 2, has anybody done this type of setup and if yes was there any problems?It is on an existing Ciscoworks server that has the most recent vers...
I am conducting some inside site surveys, I have a lot of documentation on doing a survey and have good equipment but one question I have is what should be the minimum signal strength or quality that I want to look for? For example I am thinking tha...
We are seeing issues with our Broadcom NIC, Dell, Hyper V servers with NIC teaming to seperate Nexus 2248's where random virtual servers will stop responding, sometimes the eventually start responding again sometimes we move them to a different chas...
When we were testing out WAAS we also noticed that doing a copy in windows is a lot slower than an FTP or even going to DOS and copy the file. This might show you end user experience but don't count on it as how your network is actually performing.
David,We have 3 WiSMs and one guest controller that we upgraded to 4.2.61 on Thanksgiving, it went very well and we have not run into any new issues yet. Right now we have about 96 AP's on the system with multiple remote locations with about 200 AP'...
Jump Router boundries is checked and no filters setup. It is really confusing because the setting are the same as they were before I ran the script, and it was working fine then. The only devices I see are my two seed devices which are 6509's in ou...
