Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If I start out at a remote location using the base WAVE-294-K9 and then the location grows can I apply the 8 gig RAM upgrade to it after the time of purchase to increase its capacity?
I have the following setup. Router1 is connected to MPLS provider1. We are doing BGP to the provider and EIGRP internally. Switch1 is a layer 3 switch and is doing EIGRP STUB routing. I am receiving all of the routes from provider1 to Switch1 from EI...
Has anyone tried to export their historical reports off of a UCCX 8.5 system to a separate database server? We have the ODBC driver configured and it can connect to the server if I want to use Crystal Reports to connect to the database directly. We d...
Where are the . msi packages located? I have a test server up and running with the 8.5.1 SU1 and need to get the update MSI to push out to the clients. Where can I locate the package at? I tried the below URL and I keep getting a not found from my UC...
In reading the design guides I see that I have to use the Native vlan to send all the CAPWAP traffic for the AP in H-REAP mode. I normally place an unused VLAN as the native vlan to prevent VLAN hopping. How can I do this with the H-REAP AP?
Is that command only for a hard drive upgrade or for a RAM memory upgrade? Is there any documentation you can point me to on upgrading the RAM on the 294? The reason I ask is that my account team is saying I can not upgrade the 294 RAM in the field....
So the IP's are differnt in my lab but the 10.10.1.X network is my internal LAN Network. 200.1.1.X network is the network segment that will be advertised by both Router1 and Router2. Right If I look at Switch1 I have the following output.EIGRP-IPv4 ...
This is not working as expected. I set this up in my lab and I am getting the following results. When I apply the offset list to EIGRP AS without using the interface command it modifies the metric. When I apply the interface command using the interf...
