Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi , I have the following problem: In our Network we have the following architecture: Server -- Switch -- Firewall -- Router (2911) -- (Gigethernet -STM1 Media Converter) -- LINK 100 Mbits --- (STM1-GigEthernet Media Converter) -- Router (2911)-- Fir...
Without license securityk9 on the router 2951 the interface SM-X-T3/E3 works fine, I see the CD led on and the status serial interface is up up. When I activate the license securityk9 after reboot the card status is down.
Hi at all,I have the following problem with two vpn :The vpn have worked until a week ago, now we have to restart the asa if we want the vpn again working . The problem is repeted every 4 or 5 hours.I have opened a debug crypto ikev1 and ipsec and I ...
Hi at all,I have the following problem:The primary ASA after some hours became unreachable on the Management interface and another interface while answer at ping on the others interfaces.At same time for me it' s impossible to enter via ssh and teln...
Hi,I want to know if i config a tunnel gre with ipsec and I configure the keeplive Does it works?ExamplesSide Acrypto isakmp key 6 xxxxxxx address side b !crypto ipsec transform-set xxxyyy esp-3des esp-md5-hmac!crypto map xxyy 230 ipsec-isakmpset pee...
. Where have you applied NATing? I' have not applied Nating2. Is there any link redundancy between both routers? No3. What are the minimum link bandwidth and MTU on all interfaces?Inside the bandwidht is 1 Gigabit and MTU is 15004. Which services are...
Thanks for answer and I will check the debug .What kind of Debug have to I check ?Debug crypto ipesec and Debug crypto ikev1 or what else ?Best RegardsCarmine
Cisco Adaptive Security Appliance Software Version 9.0(1) Device Manager Version 7.1(1)52 and cpu usage is 5%. In the logs I see only these errors:FW-OPS-SUP(config)# sh logging asdm 6|Feb 24 2013 14:40:16|110002: Failed to locate egress interface fo...