Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey GuysI am banging my head with this issue where a dhcp client connected to a vxlan fabric is not able to get an IP address from the server. The dhcp server is connected via OSPF with NXOS-1 and all the routing is complete.Below is the topologyI ha...
Hello Guys,
I am studying for Cisco SISAS exam and trying to learn CWA using ISE 1.4 and the test PC is connected to a 3750V2 Switch Running code 15.0(2)SE10. The problem I am having is that the redirect is not working. Switch is successfully able to...
Dear Friends,I am having a bit of trouble with a unique VPN scenario. The diagram is attached with the explanation below:1. Their is an IPSEC VPN is established between our Office router and the Service provider's router both are using public IP Addr...
Dear All,I am trying to connect my 2800 Series CIsco Office router with VPN client software from home. I can successfully authenticate and get the IP address from the pool configured but couldnt ping any LAN Ips including default gateway. I am pasti...
Dear All,Can somebody please explain what is the meaning of the following log messages on Cisco 7604 Core routers. The Core router is configured with 2 STM card configurations with Vlan assignments:7604#show verCisco IOS Software, c7600s72033_rp Soft...
HI Enes to add more I am doing a packet capture and on NXOS-2 where the dhcp client is connected I see below:On interface Eth 1/1 (Connected to NXOS-1)On NX OS Interface Eth 1/3 where the dhcp client is connected:it look like for some reason the dhcp...
Hi EnesThank you for your reply really appreciate it. I believe when you say to use ip dhcp relay source-interface vlan 30 it is on the Vlan 30 SVI ?The problem is I cannot do that because VLan 30 is using anycast gateway, so I already tried that and...
To update this thread I changed the CWA PHASE 1 ACL as below and now I can access the GUEST PORTAL only via direct link copying from the switch. The redirection is not happening when I type something like www.yahoo.com. My Client PC when on CWA Phase...
