Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been following a NAT tutorial and I have a simple to ask.Assume there is only 1 IP 209.165.100.30 configured on g0/0and we want to NAT the IP 209.165.100.29 to the HoneyPot server, where and how are we going to set the IP 209.165.100.29 at? D...
With reference to this: https://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/115904-asa-config-dmz-00.html The acl configured at the end for dmz, why is it being placed inbound rather than outbound in the dm...
http://www.cisco.com/c/en/us/support/docs/lan-switching/inter-vlan-routing/41260-189.html#diag Hi guys, with reference to the above link, it seems to miss out on the router's configuration. What I would like to know is should we also configure stati...
Hi guys,
I have seen tutorials that include and omit out domain name in the configuration of the SSH in a router/switch.
What is the significance of including it? And does it have any impact if it's omitted?
Hi Seb,Thank you for the reply.A question. Why does the 7206 need a route to the 10.1.0.0/16 network? I thought the "IP routing" command in the 3550 takes care of that already?
Hi Iwen,Thanks for the infor. Below I have gathered the commands (based on your tutorial) needed to set it up and have commented some as optional. Pls take a look and correct me if I'm wrong.crypto key generate rsa label SSH-KEY modulus 4096ip ssh rs...
