Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, thereI have a Cisco 5585-X. one of the context is configured with transparent mode. OSPF is used for routing between the two layer 3 devices on the inside and outside the interface respectively. However the hit count for OSPF shows 0. Could someo...
We are not use the 4G module on ASR 3925. Also, the router reporting CELLWAN-4-CELLULAR_MODEM_SKU_MISMATCH Is there a way to remotely disable the 4G module with a command rather than physicall removing the module? Thanks
Hi,Our ISE 2.4 nodes take up lots of resources from the original OVA file deployment. We would like to resize it based on the usage in vmware. Would there be any issues? Any suggestions if we do resizing?
have a widows server (VM) complaining"The system detected an address conflict for Ip address 0.0.0.0 with system having network hardware address 1C:DE:A7:BD:2B:8D. Netwrok operations on this system may be disrupted as a result". screenshot attached. ...
Thanks for the linkthe vlan is acctually layer 2 (no SVI)based on the link provided, for lay2 MTUpolicy-map type network-qos jumbo class type network-qos class-default mtu 9216system qos service-policy type network-qos jumbo I don't want t...
Thanks, Greg! The ESXi host does have hyperthreading enabled. If we go with half of the CPU allocation, that is 6x (3515) and 8x (3595), should the ISE VM nodes be running ok?
Thanks for the reply!the two PAN (Medium/3595) VM nodes have 16 CPU + 64G MEM, while the two PSN (Small/3515) VM nodes have 12 CPU+16G MEM. Look at the performace of the VMs, CPU usage (average 3%, range [1-10]%), MEM usage (average 7%, range [1-18]...
On the cisco 2960, we have IPDT disabled and IPDT delay 10 is configured. Seems, the switch still sends ARP probes when the link from down to up. Any other suggestions?Switch Ports Model SW Version SW Image------ ----- ----- ---------- ----------* 1 ...
Hi, Checked with the server engineer that the gratuitous ARP is diabled already. On the cisco 2960, we have IPDT disabled and IPDT delay 10 is configured The switch, having IPDT disabled, sends ARP probes, while Windows server checks IP conflict whe...
