Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I met a problem with my C1921/K9 router. CPU usage on it is constantly 90%.
When I used "show process cpu sorted", I found the process called "Switch Link Moni" occupied 75% of CPU resources.
I have tried searching what the proces...
Hi Team,
Is there some way to know the input/output rate of sub-interfaces?When I use "show interface fa0/0.1" , there is nothing related to traffic information.
Many thanks.
router#sh int fa 0/0 | i put rate 5 minute input rate 4000 bits/sec, 8 pa...
Hi team, Here's something about NAT . I want to do NAT to translate 192.168.21.21 to both 202.100.10.1 and 61.144.1.252 for the server can be accessed by two Internet addresses. Configuration is as below: interface fa 0/0 ip add ...
This morning the CPU usage rate of my Cisco 2811 was constantly 99% , which caused lots of packets lost. When I used the command "show process cpu sorted ", I was quite confused that I couldn't find the process which was wasting the CPU resource...
Hi Stephen,
I'm facing a similar problem and it's really puzzling me. How could EEM/TCL with SLA do a packet-loss detection and automatically disable the path with problem?
Two paths which I am using now to access the Internet are both via s...
Hi Mark Malone,
Thank you for answering the question. SNMP/Netflow are surely good ways to monitor the traffic . And configuring QoS is also a good way .
It is really a pity sub-interfaces' rate cannot be directly shown by "show interface".
Well , the subnet 169.254.1.0/30 is only for connection . The router is a CE(client edge) router linked to ISP. There are two static routes pointed to the CE router on PE device. I have just simplized the model .PE (Provider Edge):
interface gi 0/1/2...
