Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,remote vpn users connect to PIX(7.2) outside interface, but need to have these clients access the Internet through the PIX outside interface as well. Need this because PIX IPs are registered and enabled to access certain electronic libraries. O...
Hello, If you have a separate voice vlan across a wireless bridged network, how could you configure qos to put the entire voice vlan in priority over the data vlan ? Thanks.
Hello there,I you have a separate voice vlan across a wireless bridged network, how could you configure qos to put the entire voice vlan in priority over the data vlan ?Thanks.
Router outside ASA has connections to two providers and I am given a subnet of 16 IPs from each.If I try to configure a second static NAT on the ASA with a different real ip but same inside ip I get 'duplicate NAT etc..' Any ideas ? I need to configu...
Need to connect two PBXs with PRI using access routers. How would we achieve a 'trunk' connection between the two PBXs, is the 'Network Side ISDN PRI' the appropriate feature ?Thanks.
ananddiwakar, this is exactly what I am after as well: block all incoming calls to a specific phone.The provider sends me 3 digits which match the phone extension.If I try to add a translation pattern to this live ip phone extension with a "block thi...
Sorry to bother you all. I have seen in a config that connection plar has been used, I thought you can use plar only with fxs/fxo ans E&M. Has anybody seen it work with e1?Thanks.
