Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
Is there any command for snmp to send traps when temperature raise or fall from defined threshold on ASR100 series router? or Is this something happen by default by enabling 'snmp-server enable traps alarms' command?
Regards,
Godwin. S
Hi All,
Hi,
I have a silly question.
If I have L3 switch with VLAN 10 SVI enabled for OSPF without passive. I have 2 neighbor routers and a firewall on same vlan (via access ports). However I want not to send multicast only for port connecting to fir...
Hi,
With respect to bug in below link, Is there any way to check and confirm if the switch IOS had been installed by setting boot variable and reload instead of install all?
Bug: https://bst.cloudapps.cisco.com/bugsearch/bug/CSCuy08068/?referring_s...
Hi,
Can someone advise on if C6840-X-LE-40G supports FHRP, as I have found below from data sheet
"High availability: Two Cisco Catalyst 6840-X Series Switches can be combined into a VSS. In addition to high availability VSS, provides ease of operat...
Hi Reza,
Understand that L3 switch does not see any packets from Firewall as firewall is not running OSPF. But what about on Firewall side, will firewall see ospf packets from L3 switch, as OSPF is enabled on switch side?
Hi Reza,
Thanks for your reply. My question is simple as below.
If I want to disable OSPF hello messages from particular ports from a VLAN, how to achieve it? I know if we want to disable it for complete VLAN, then we can do it by 'passive interfac...
Hi Seb,
I have got a situation reg DHCP snooping. Lets say below is my topology.
Router A (L3 with DHCP pool configured. DHCP snooping disabled)
|
|
|
Switch B (L2 switch (trunk links)-DHCP snooping enabled: trust Router A link and u...
