Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
One of our ME3600 units has developed a problem where we would lose IPv6 Neighbours and OSPFv3 neighbours, followed by the device not passing MPLS traffic. IPv4 traffic suffering bad packet loss.I discovered that devices attached to the Gigabit ports...
I have a requirement to pass a Xconnect over an RSVP-TE signalled tunnel, but I do not have the option to add a preferred-route so the Xconnect always passes over LDP signalled LSPs.All examples I have seen suggest to use preferred-route under xconne...
I have 2 Juniper MX5 routers which connect with 2 ME3600 in an MPLS ring. They all run as PE routers as I currenlty do not have a requirement for separate P routers.I plan to have the full BGP internet table imported into an Internet VRF in each MX5 ...
Can QinQ packets be passed through a 2960 switch using VLAN trunks?I am receiving QinQ packets from a service provider on a trunk into a 2960 switch which then connects to an ME3600 via another trunk port which is configured with service instances fo...
Hi,I need to setup a Cisco 2921 with data license to work as a LNS using local authentication for just a handful of remote clients.Could someone advise on how best to configure this so that the all the tunnels are terminated onto a VRF and recommend ...
Hi,We implemented "platform acl egress-disable" and have not had any further problems with the device, so it looks like this may well have been the workaround for the bug.Thanks for your help, our Cisco TAC contacts didn't offer this as a solution an...
Hiwe have lowered the amount of traffic traversing the unit and it has stopped breaking so often, but we still do not have a resolution.we have been sending all manner of logs and information into TAC but they are still working on it.thanks for your ...
Hi Akash,Thanks for your help.The RSVP-TE tunnel is up ok and I have a route for the second loopback through the tunnel using a static route. But when I configure the Xconnect to use the second loopback I get the following error:MPLS config error: 10...
Thanks for this.I have tried setting up another tunnel interface between different loopbacks which comes up fine, however when I try to xconnect between the new loopbacks i get an MPLS Config error saying the loopback address is not a valid LDP id, u...
