About andrew-hunt

andrew-hunt · 06-24-2015

We have a number of 5508 WLCs running 7.6.100.0 code where we authenticate the management user again...

andrew-hunt · 02-25-2014

Yes, NTP is fine. This is a four-node ACS deployment and everything was working fine until recently....

andrew-hunt · 02-25-2014

Thanks for the post but this is not our issue. We don't see that output in the log. The output is:Fe...

andrew-hunt · 02-20-2014

We have a four-node ACS deployment and one node is experiencing problems when handling TACACS authen...

andrew-hunt · 02-26-2013

Hello all,Is anyone aware of the CLI command to enable / disable the DHCP Addr. Assignment required ...

andrew-hunt · 10-17-2012

Hello all,I am trying to use RADIUS authentication for Brocade SAN switches, specifically the HP AJ8...

andrew-hunt · 07-23-2012

Hello all,I have a 4506-E catalyst with a WS-X45-SUP6L-E running cat4500e-lanbase-mz.122-54.SG1.bin....

andrew-hunt · 01-20-2012

We have a number of 5505 ASAs at remote sites all of which are configured to connect to one of two h...

andrew-hunt · 10-19-2011

Hello Nik,Looks like you're right. I have just tried with 12.2(55)SE4 and the RPS works as it should...

andrew-hunt · 10-19-2011

Hello Nik,We have done more testing. We have an identical set-up in our Dubai office: 4 x 3750E swit...

andrew-hunt · 10-18-2011

Hello Nik,We have tested using all four 3750E switches in the stack and the behaviour is the same - ...

andrew-hunt · 10-17-2011

Hello Nik,The info you need is in the attached text file. Just to reiterate one point and that is th...

andrew-hunt · 10-13-2011

I have a problem with a 4-switch stack of 3750E-48PD-SF catalysts that are connected to a single RPS...

TACACS Authentication to WLC fails - WLAN user instead of MGMT user