Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, i have a problem with my L2 port-channel between 2 SW ME-3400-24TS-D (12.2(44)SE5), there is a unequal load balance and i don't know how to fixed. Should I change the load balance method?.All four ports have the same config, except one (int fa0/1...
Hi everyone I need your help on this, I have this problem, I need to enable STM-1 on this sub-module: 1xOC3 ATM SPA, more specific:Mod Ports Card Type Model Serial No. 2 0 4-...
Hi,I need to replace the fan on a Cisco 3725.Anyone know if the fan of some other equipment is compatible with my 3725?..Can you tell me which model of router has a fan with similar characteristics that may serve a 3725?.I leave some specs of my 3725...
Hi everybody, can someone can help me with this case. Would appreciate it greatly.I have 2 switches c3750 which I want to install in stack to replace two Nortel switch that I have in production. When connecting my new stack of cisco switches to a cis...
Hi everybody,I have a problem connecting a PC in a TwinGig Convertors (GLC-LH-SM). I want to connect a PC with a fiber cable on the supervisor WS-X45-SUP6L-E of my Switch 4500E.The default configuration mode is X2. As I want to deploy Gigabit interfa...
Thank you Giuseppe for your reply, are you saying that the only problem with my previous configuration is this:I should configure the framing with this command "atm framing sdh" instead of "framing sdh".. like this?controller SONET-ACR 3 atm framing ...
Hi Reza,Well I guess that the fiber is SM. I have temporarily connected the PC to another device that is not cisco and I can achieve connectivity. So I guess that is something wrong with the 4500. However how can I see if the Fiber is SM.Can you tell...
Hi, I'm sorry ... I attached the right files. Please let me know if you can open and view this files.Also I Attached a file, where you can see the changes apply to the swicth in the moment of Crash.Thanks a lot.Regards,
It´s a functional network with FR, this is the actual config on the interfaces:!interface Serial0/3/0 no ip address encapsulation frame-relay IETF ip route-cache flow load-interval 30 frame-relay traffic-shaping frame-relay lmi-type cisco!interface S...
