Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a Cisco 3845 with a Configuration register set as 0x2102.A boot variable set to:boot-start-markerboot system flash c3845-advipservicesk9-mz.124-22.T.binboot system flash c3845-advipservicesk9-mz.123-14.T6.binboot-end-markerand a flash fi...
Has Cisco made any comments on this and their WLAN equipment?See links below:http://www.techworld.com/mobility/news/index.cfm?NewsID=1551&Page=1&pagePos=5http://www.auscert.org.au/render.html?it=4091
Hello,I have some CatOS 4006's (ver 7.4(3)) I have set RSPAN up on. Source port on one 4006 direct fiber connected to another 4006 that has the RSPAN destination. When I look at the sniffer trace some of the packets are out of order. Example - Ping...
Question for all Cisco 3745 owners. Does your SYS light say on (green) when the router has finished booting? Either on the front of the router or the back (by the console port)? I have TWO 3745's that blink green when booting then go out. Accordi...
Can anyome tell me what this means? This is from a Cat4006 running 7.4(2)2002 Dec 12 13:56:16 CST -06:00 %SYS-4-P2_WARN: 1/Traffic from permanent host 00:08:02:ab:80:0b but seen on incorrect port 2/332002 Dec 12 13:57:34 CST -06:00 %SYS-4-P2_WARN: 1...
Would it be possible to use IPSec (ESP in Transport Mode)? This way I'm using the same IP header. Can I just say anytime a packet needs to go thru either PIX - encrypt it and forward to the other PIX? Does this make sense?
