We have the following scenario:Between two locations we will have a 50Mb/s ATM link. This link will be utilized for general purpose IP traffic as well as for 25Mb/s MPEG video contribution. We want to be able to use the full capacity for IP traffic...
We have been using 3548XL switches until now, when we are about to deploy 3550 switches.Using basically the same configuration as for the 3548XL we encountered the following problem : when the first stack (of four switches) was connected via a GBIC t...
We're using the following dialer and have 4 BRIs in a rotary group.Every time the dialer tries to set up a new channel, it starts with the first dialer map entry, finds that the line is busy, waits for 30 sec and tries the next number. This process ...
I experienced the same problem when upgrading the laptop to XPsp1 from W2k.Turning off the Zero Wireless Configuration service on the laptop seems to make things work a lot better.
I may not have been perfectly clear describing our scenario, but will give it another shot. The important thing to note is that we have two independent systems utilizing the same ATM link, one is the Cisco WAN (3662 one end, 7200 the other). The ot...
Hi.Thanks for your reply. As you have pointed out some of the config was missing in the question. "ppp multilink" was configured.Using dialer redial interva 5 attempts 3 and setting the wait-for-carrier-time to a low value seems to have sorted this...
