tnatsukawa
Level 1
Level 1
Member since ‎04-27-2002
‎08-18-2017

User Statistics

  • 24 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
First Discussion
5 Discussion Posts
20 Discussion Posts
10 Discussion Posts
1 Reply
10 Replies
5 Replies

User Activity

Hi. I'm having trouble with an attended call transfer using a Cisco 2611XM with a T1-CAS to a PBX and a SIP telephone. The scenario/symptom is:1 the SIP telephone calls extension 6000 on the PBX via the Cisco 2611XM. The call establishes.2 the SIP te...
Hi! My Cisco 3620 experiences very high CPU utilization with modest amount of traffic (about 600 kbps) over an ipsec vpn tunnel. The CPU utilization is 98%, and 97% of that is due to interrupts. If I generate more traffic, the router freezes (no resp...
Hi, on my Cat6k-MSFC I'm having trouble setting DHCP manual bindings:Router(config)#ip dhcp pool GuestRouter(dhcp-config)#host 172.16.69.2 % This command may not be used with network pools.Router(dhcp-config)#hardware-address 0800.3712.9d76 % This co...
Hi, I'm snmpwalk'ing dot1dTpFdbAddress on my Catalyst 3524 to retrieve its MAC address table, but it doesn't seem to give me all MAC addresses... Some MAC addresses, that I can see when I do "show mac-address-table", are missing from the output of s...
Hi,One of our Catalyst 6509s recently started logging this funny message on syslog:%SYS-3-SYS_MEMLOW:Malloc usage exceeded 90%When I checked with the Error Message Decoder page at http://www.cisco.com/cgi-bin/Support/Errordecoder/error_decoder.pl?ind...
Community Statistics
Member Since ‎04-27-2002 06:39 AM
Date Last Visited ‎08-18-2017 03:51 AM
Posts 24