Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How do i renumber a switch ie when there is an existing switch 3 in the stack? Do i have to un-provision switch 3 and 4 and reconfigure ?
I tried the following below and rebooted but it did not work.
conf t
switch 4 renumber 3
exit
reload
let me explain further. My Cisco 3650 connected to a vendor Ethernet switch at 100 meg full duplex. Wan circuit is 10 meg. Will I experience any issues doing this?
ANYONE KNOW THE USERNAME / PASSWORD FOR THE CONTENT-ENGINE WHEN YOU OPEN UP A SESSION TO IT? ON OUR 2651XM'S WITH CONTENT-ENGINES THE USERNAME IS admin and the password is default. THIS DOES NOT WORK WITH THE NEW CONTENT-ENGINES INSTALLED.
We recently received our new shipment of 2821 routers with the nm-ce-bp modules,does anyone know the username and password this module is looking for?our 2651xm routers with content-engines the username is admin and password is default. This does n...
