Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone run intp an issue with gui login failure on the Cisco ACS. None of the local passwords are working and there is no error when entering the credentials in the GUI. It just says incorrect login. The reset-password command is failing when ...
I have a cisco 3945E which is able to successfully establish a IPSec connection. But after about 15 minutes the connect drops and I get the below error.CERT is NOT valid as per profile.I am trying to determine why the certs would initially be valid ...
I have an active/standby ASA in my network. I would like them both to be monitored by hp openview. Right now only the active ASA can be viewed by HP openview and there is ip connectivity to both. Are there any special steps that must be taken in o...
I am trying to increase the mtu on an etherchannel but I am getting an error saying that the gig interface does not support the mtu change. the connections are copper connections b/w 2 6506s.TIA,
I am running into an issue with multicast and HSRP on a hybrid 6500. The 6500 has redundancy implemented and there is a primary and alternate ip address required for each interface. Unicast routing is using a both the primary and alternate ip addre...
I updated the latest English locale files for CME 4.0(2) and I am still seeing the provisioning failed error. I am using a 3845 with 12.4(11)t. Here are the commands I used.tftp-server flash:mk-sccp.jartftp-server flash:td-sccp.jartftp-server flash:...
The inside network is 1.1.1.0/24. Below are the ACL's and NAT rules.ip local pool remotevpn 1.1.1.245-1.1.1.246 mask 255.255.255.252access-list INSIDE_nat0_outbound extended permit ip any 1.1.1.244 255.255.255.252 global (OUTSIDE) 1 interfacenat (IN...
Hi Kanishka,I tried this command but it did not help. the host uses it's own ip address as the default gateway. Is this normal? How can I change this?Thanks,
I was able to set up the client vpn connection but once I have a connection I am not able to connect to any devices on the inside network. The client also gets a default gateway which is the same as the ip address. Is this normal? I am only able to...
