Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have 7K with M1/M2 Modules only connected to 5596UP switches.Does it make sense to create a policy type "Network-QoS" on 7K and 5k switches? or just create "QoS" (ingress) and "Queuing" policies?or it is a good practice to follow MQC guideline an...
Cisco PI 1.3 How do you find device by MAC or IP address? I want find out on which device the end host is connected by entering MAC or IP address.I was able find the end host with LMS 3.2 Campus Manager->User Tracking->Report. My end device is Cisco ...
ASA 5520 8.0(5)I want guest AP users in DMZ to browser thru dmz controller. User is receiveing IP address (172.17.0.1) from WLAN controller and can ping 172.17.1.254 &192.168.1.225, but cannot ping 4.2.2.1. Even controller (192.168.1.225) cannot pi...
Site-to-Site tunnel not coming between ASA 5520 and ASA 5505. Both has 8.0(5). Following is the config for HQ and Remote Site.HQname 172.16.4.0 Homeless!interface GigabitEthernet0/0 nameif outside security-level 0 ip address xx.xx.xx.xx 255.255.255.0...
I have a two fiber connection from our Central Office(6513) to Remote office (6509). I have a requirement that on the remote office if one of the fiber goes down, the second fiber should work as a failover. I am planning to use SUP720-3B SFP to conne...
I added & it is not workingroute dmz 172.17.0.0 255.255.254.0 192.168.1.1 1access-list outside_acl extended permit ip any 172.17.0.0 255.255.254.0 access-list outside_acl extended permit ip 172.17.0.0 255.255.254.0 any access-list dmz_in extended pe...
show crypto isakmp saThere are no isakmp sasPhase: 1Type: FLOW-LOOKUPSubtype: Result: ALLOWConfig:Additional Information:Found no matching flow, creating a new flowPhase: 2Type: ROUTE-LOOKUPSubtype: inputResult: ALLOWConfig:Additional Information:in ...
