Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have two 3845 routers set up using HSRP at two locations (4 routers total) connecting inside to a pair of ASA 5520 (Active/Passive failover) on each side. These links are used for internet access and they work great under normal operating conditi...
I have a site to site tunnel between two 5520 ASAs. Tunnel is up but when I try to talk to the other side, the implicit deny on the inside interface of the local ASA blocks the traffic. When I ping, the tunnel comes up but in the logs it says it is...
Hello All,In our ASA logs I am seeing alot of this error message:ASA-6-722036: Group <GroupName> User <UserName> IP <x.x.x.x> Transmitting large packet 1500 (threshold 1406) Connected using AnyConnect client. One user has complained of having issues...
I have a 3845 ISR that I have been managing for a couple years that has a traditional ACL based config. We just purchased a new 3845 for redundancy and it arrived with the zone based config from Cisco. Any opinions on whether I should take the exis...
I have a 5520 ASA that I am trying to upgrade from 8.2 to 8.3 and have an issue where every time I copy a file from tftp to the local flash (or http to flash or disk0) the file copies, writes the file and immediately re-boots. When it comes back up, ...
Well I figured it out...too much memory installed by vendor to upgrade the ASA. I did a 'sh mem' and the free memory and used memory was totalling 200%. 111% and 189% respectively. Took out two sticks and booted up, works fine now with two GB of R...
Thanks for the quick response. I have a couple follow up questions to help me understand this better.After adding the second default route in the ASA, I will need to add tracking to determine if a route is available. What is the best network object ...
