Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
so I got a cisco router 880, which I wanna configure to get access to its network via vpn , and also configuring remote desktop connection to one of the server in my LAN from home.
I tried a lot of combines, and i admit I m not that good ...
Hi all,
so I got a cisco router 880, which I wanna configure to get access to its network via vpn , and also configuring remote desktop connection to one of the server in my LAN from home.
I tried a lot of combines, and i admit I m not that...
Hi all,
so I got a cisco router 880, which I wanna configure to get access to its network via vpn , and also configuring remote desktop connection to one of the server in my LAN from home.
I tried a lot of combines, and i admit I m not that good ...
Hello all,
so my company needed to change a router and replace it with an 880 cisco router.
the architecture is very easy, Two interfaces: one for LAN and the other for the WAN.
i had to create a VLAN for the FE0 interface, cause I couldn't tur...
hi everyone,
I m changing a PFSense router with a Cisco. And I m bit stuck with the configuration ( the NAT rules ).
In the attachements you'll find the Pfsense NAT configuration table with the ACL used for that.
Please help me translate it to CISCO...
Not that much of crypto I guess. And i don't think it will cause that much of loss in bandwith neither.
I setted the int on full, but I think my router isn t convinient.
Thanks a loot
How can i add a default route ?
CMA#sh vlan-switch
VLAN Name Status Ports---- -------------------------------- --------- -------------------------------1 default active Fa2, Fa3200 VLAN0200 active Fa0300 VLAN0300 active Fa11002 fddi-default act/un...
