Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a problem with a couple of ATM DS-3 point-to-point links. I have a 3745 router in the middle. The two distant ends are 2621 routers. This is the senario- some time over the weekend something happens and the ATM VC go to an INAC status. I look ...
I have a 6608 blade in our Cat6509 with two T1 ports setup as T1-CAS ( for our old phone system) and two ports setup as T1-PRI (connection to the TelCo). Is it possible to use MRTG to monitor the channel usage on those ports? Thanks Dan
When you open a session with the SM-X-ES3-16-P module you should have seen the notice (below) about how to exit the session. You need to enter CTRL+a CTRL+q to exit the session. Establishing session connect to subslot 1/0To exit, type ^a^qpicocom v1....
I have the command 'oam-pvc manage' on all the PVCs. We do not have a service provider. We use our own equipment from end to end. Our radios us our own FCC licensed freqs. We take a router install a DS-3 card, hook it up to one of our radios, then at...
I thought about that. I was hoping to get some history gathered to chart peek times and such. I dont see a way to do that with the tool in CallManager.
