Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!! once again, i have to choose between design opinions and I'd like to hear about your exeperiences... Now referred to internet access. I have several customer needing to learn full internet routing and stablishing bgp connection with our PE's...
Hi!!!I work for a small internet service provider and we are migrating our old core to MPLS over Cisco devices. Up to date, all links and loopbacks in the core were using public address. Now, when thinking on migration, a doubt arises. Has any sense ...
Hello, I'm trying to get using snmp who is the root bridge, from a non-root bridge- Although I've found an OID awcDot11TpFdbCurrentBSS - 1.3.6.1.4.1.522.3.12.5.1.15which is supossed to give me the BSS to which the station is currently associated, I...
Hello, I've deployed a WLAN using a root AP and some Repeaters (AP352). I've configured the the Ciscos to validate clients by MAC address, using a RADIUS. Is there any way to centralize authentication in the root AP. Now, I have to configure my radiu...
HelloI've read in the manual of BR352 that max distance you can configure (parameter max distance) is 40 KMs. Does it means that farther distances wouldn't work? What would it be tha furthest distance (not taking in account problems related to attenu...
hi!! thanks for such an interesting discussion... after reading all the post...what about using private addressing on internal links and public just for loopback addressing? We would save for many public addresses, still being able to id every link (...
Hello I think agregatting channels is not as simple as it seems. If you simply use three bridges in each site connected to a switch, you may be would have STP problems, but if trying etherchannel configuration, load balancing would be done by process...
supossed i have the enough PIRE in both sides to overcome the attenuation due to the distance and supossed i have LOS. What would it be the furthest distance due only to hardware limitations?
When adquiring AP's in the ETSI ZOne, the higher output power you can use is 50 mW, to avoid using higher EIRP than the allowed by ETSI. If you had an US device, you could use this 100 mW configuration. Somewhere in the device you'll find a label tel...
Hello Michael. I have the same doubt as you. After searching in several sites I think I have one answer that may be right (but not sure ). You can set up a RTS packet size treshold. I thhink DCF is based on RTS/CTS, so PCF will be used when packe...
