Is there a command to run diagnostics on a single switch port on a line card in a 6807-XL Switch? We have a C6800-32P10G and the LED for port 32 on that card we have all ports disabled and the other ports are solid amber/orange. There are no SFP's ...
We're upgrading our 300Mb circuit with a full 1Gb circuit and I'm wondering what the recommended inbound policing percentages are for burst-normal and burst-max.
on the 300Mbps link we have:
police 275000000 55000000 110000000 conform-action tran...
I'm having a problem where my ISR 4K router at my HQ will cannot form a macsec session to 3 of our Remote Sites over 3 different VLANs. They're all ISR 4451 routers with the same NIM-2GE-CU-SFP module. However the 3 remote sites can form macsec ses...
We have 4 6807's that we're going to use to replace 2 6509's. Each 6807 has a SUP6T engine. Can we put all 4 switches in VSS mode in a single domain? If so, does anyone know of any design documentation that covers this scenario?
Not Sure if this has been answered, but you have to configure the interface with the history command and any options you want.
ROUTER1(config)#int s1/0/0ROUTER1(config-if)#history bps/pps ? all Include all counters crcs ...
We have 3 systems monitoring our 6807 switches that have this message in their log. How can we tell which system is causing this "error" to generate?
The systems are
PI 3.3
Whats Up Gold
Statseeker
What I want to say: "Get Solar Winds and use prime for wireless heat maps." I'm having similar issues too. Haven't been happy with PI for a while. Every 3.x update breaks something else. I hope you find the fix and hope the solution is not upgrad...
Thanks for your reply. So for the 1G link I'm moving to, the numbers are as follows?
1,000,000,000 * 1 byte/8bits *1.5 ==> 187,500,000 and 375,000,000?
Any reason to put less than full rate of link in policing statement?
We currently have a 300Mb ...