About mrjelly

mrjelly · 09-06-2024

Hello,We get alerts when our CES instance swap memory goes above 60%. This appears too low as there is no registered degradation of service.Is there any recommendations on this to adjust these to be more helpful? Thanks

mrjelly · 05-07-2024

Hello,we currently have room bars set up in meeting room and are looking to implement Proximity.However I get a message that I need to accept when my laptop connects to the room bar over Proximity.The message states 'Could not verify device identity....

mrjelly · 04-15-2024

Hello,I have a switch I am unable get a prompt on the console port.I can SSH to it, and have confirmed that the baud rate and stop bits are correct from the console switch. There are two other switches that I can console to.The differences are that t...

mrjelly · 03-15-2024

Hello,I am getting an error with a printer authenticating with Cisco ISE for dot1x.The error is "Subject not found in the applicable identity store(s)".This is an LDAP identity lookup. It is looking for the alternative subject name DNS, and this is a...

mrjelly · 03-13-2024

Hello,Is there a way to see an FTDs ssh-access-list through the FMC and even see what's on it?It appears that to setup an FTDs SSH access list is to use SSH access (or from the console too?) Using the Threat Detection CLI in the FMC and selecting 'Sh...

mrjelly · 05-10-2024

Solution to this was... the cable was unplugged from the console switch to the primary switch.All other switches in the stack were plugged in.It's ridiculous I know but the error message was not help either, why an unplugged switch was displaying the...

mrjelly · 04-17-2024

Hello, thanks for the reply.I did consider this too. The Baud rate, stopbits and parity bits are matching on the switch console line and the console switch (this is an Opengear console switch.Additionally I assumed (perhaps wrongly) that if 3/4 of th...

mrjelly · 04-16-2024

Thank you, yes apologies if I did not mention, aaa new-model is enabled, as such I can't set login local.That is why I'm wondering (after seeing Authorization Failure) that the missing config is aaa authentication default local.However there is no aa...

mrjelly · 04-16-2024

Helloshow run | s line - line con 0stopbits 1line aux 0stopbits 1( I left out vty)line aux 0 is not configured on the other switches interestingly Yes I have checked the switch stack and this is the primary. I have also tried all four console ports a...

mrjelly · 04-15-2024

Additionally this is a switch stack, on the other console ports I am getting '% Authorization Failure'

Member Since	‎03-14-2019 10:05 AM
Date Last Visited	‎10-09-2024 03:54 AM
Posts	50
Total Helpful Votes Received	5

User Statistics

User Activity

CES swap memory threshold alerts

Proximity - Remove 'Could not verify device identity'

Unable to get console access on switch 3850 - Blank terminal

Cisco ISE Subject not found in the applicable identity store(s)

Changing FTD SSH access-list

Re: Unable to get console access on switch 3850 - Blank terminal

Re: Unable to get console access on switch 3850 - Blank terminal

Re: Unable to get console access on switch 3850 - Blank terminal

Re: Unable to get console access on switch 3850 - Blank terminal

Re: Unable to get console access on switch 3850 - Blank terminal