Solved: 2.4 Only

simple818 · ‎06-24-2018

I'm trying to troubleshoot some legacy devices. Is there a way to setup an SSID that is 2.4Ghz only? I've been playing with it for a bit and digging into the RF Profiles but I'm not making a ton of progress.

Adam R MS | CISSP, CISM, VCP, MCITP, CCNP, ITILv3, CMNO
If this was helpful click the Kudo button below
If my reply solved your issue, please mark it as a solution.

Philip D'Ath · ‎06-24-2018

I believe if you open a case with support they can enable that as an option. Otherwise no.

View solution in original post

Philip D'Ath · ‎06-24-2018

I believe if you open a case with support they can enable that as an option. Otherwise no.

simple818 · ‎06-25-2018

@Philip D'Ath wrote:
I believe if you open a case with support they can enable that as an option. Otherwise no.

I contacted support and they enabled that option. Thanks for all the feedback. I didn't think about dropping the 5Ghz lower as well.

Adam R MS | CISSP, CISM, VCP, MCITP, CCNP, ITILv3, CMNO
If this was helpful click the Kudo button below
If my reply solved your issue, please mark it as a solution.

javcasti · ‎07-25-2020

So it means it is not available unless you ask for it via a support case?

Philip D'Ath · ‎07-26-2020

>So it means it is not available unless you ask for it via a support case?

Correct.

kevinl2 · ‎06-24-2018

What Philip said. My workaround if it's just for testing, is to drop the 5Ghz power to the absolute minimum.