Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am trying to log all commands executed on the Cisco Router. And it is working fine. However it wont show who executed the commands. It just shows command was executed *Nov 15 00:38:56.356: %HA_EM-6-LOG: cli-match: configure terminal Command Exe...
Hi,Just wanted to know if we can change the redirect url. By default it starts with the hostname of ISE. I will have four PSN nodes and want that url is actually the Load Balancer Url rather than ISE node. Since ISE isintegrated with AD domain.local...
Hi,We have got our AD integrated to our CUCM 8.x. Now we are deploying Cisco Enterprise attendant console. Attendant console is getting directory information from AD for internal contacts.Now my organisation is looking to add external contacts to the...
Hi,We used to have cisco ATA 186 for Fax machines with Pass through mode which worked fine with both inbound and outbound mode. Wherein we had configured audio mode parameters on ATA 186.But now using ATA 187 for the same place and same config. Only ...
Hello Team,We disconnected some host/storage fc ports from one MDS switch and connect to 2nd MDS switch. now I want to connect both 1st and 2nd MDS switch through ISL.If I run "sh running-config" on 1st switch, it is showing FCIDs for those host/stor...
Hi,You can consider Prime as baby. As per them it is still growing. One of the worst problems I have with Prie is reporting. as with any normal toll you will have tx/rx utilization reports generated in graphical form..But with prime i have to take sc...
Hi Marvin,We had logged case with Cisco for this and finally after few days of troubleshooting it came to surface that there is filter in Prime to drop anything else apart from 0,1,2. this is there to keep Prime database low.RegardsAijaz
