Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We use the inventory under organization to keep track of all our hardware.Why is the inventory not showing SFP modules, external antennas and additional power supplies?Is it possible to get information about those components?Regards,Henk
Greetings,We are currently utilizing Meraki Sponsored Guest for our Wifi Guest access.However, we’ve encountered an issue where the sponsored domain user, upon receiving the email and clicking the link, is redirected to a Meraki page that consistentl...
Hello,We have a stack of 3 Meraki switches.Two switches should be removed from the stack and the last switch should be converted to standalone switch.What is the approach to convert a 3 member stack to just one single switch without loosing the confi...
How can I prevent my switches from using it's name including mac address when using DHCP.Just want that it uses it's name without MAC address.Example:Now it is registered in DHCP/DNS [switch-hostname]-[mac].domain.comI want it to register in DHCP/DNS...
Hello,If a Meraki switch has a static IP address does it fallback to DHCP if it cannot reach the gateway?I understand that MX and MR devices do, but not sure if Switches also do this.
Greetings,We opened a case at Cisco Meraki and they came up with this solution in our case.================= 8< ====================Yes services like Microsoft Defender would certainly cause this issue as these services are accessing the link to scan...
If it is that critical for you why not create an additional SSID with complex WPA key that is distributed to your managed clients by policy. This can be used as a backup in case the AAD fails. The additional SSID is disabled in Meraki and when AAD fa...
Simple solution if you have a layer 3 switch.
Create a port as a router port, so no switchport and configure an IP address on it.
Create a port with access port in vlan you want to have up.
Connect both ports to each other with a standard CAT5 or 6 c...
