Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am having issues with global vrf route leaking.It is working in an evironnement that has a dialer interface or a static route, but if the isp at the customer location use a dhcp connection, I can't redistribute the global route into the vrf.Is t...
Hi,I am currently renewing the IOS-CA certificate because it is expired. The new certificate is in place and I am signing new certificate request with the new IOS-CA certificate.The only problem is when I am trying to authenticate with the VPN client...
Hi all,I have a weird problem, when I am using the whitelist/blacklist on a specific zone on the Zone Based Firewall, I have a boot time of 8 minutes prior to be able to log on the router using the console port. If I remove the url-filter, the boot t...
Is there a way to reboot only the 3G modem card on a cisco router without rebooting the router? We have a cisco 881G with a PCEX-3G-HSPA-A card and sometime our ISP ask us to reboot the modem. We use the 3G card has a backup connection. If we reboot ...
Hello,I am tried to understand the zone-base-firewall. I am using it on a cisco 891 with ios c890-universalk9-mz.151-2.T1With the current configuration, everything is working fin exept the trafic from the private zone to the Internet zone. My vpn tun...
Hi, I am having the same problematic. I am wondering is it is possible to have the websense server on a different vrf. I did some route leaking with bgp to be able to access the websense server but it does not work.
Hi,I just had the same issue after an ISP change. From one of the vlan, telnet was working on port 80 but users were not able to browse the Internet. I added "ip tcp adjust-mss 1346" on that vlan and it has fixed the issue and browsing is now working...
It seem that if you remove the service-policy urlfilter from your policy-map, you can now do your change without any problem. The more pattern you have in your parameter-map for your whitelist, the more time it will take for the change to be applied....
I have found the correct procedure.Router(config)#service internalRouter(config)#exitRouter#test cellular 0 modem-power-cycle 000048: *Feb 8 16:04:50.975: %CISCO800-2-MODEM_REMOVAL_DETECTED: Cellular0 modem is now REMOVED000049: *Feb 8 16:04:50.975...
