Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear folk,Could any one please advise for my case below:I am going to setup Auto-Attendant feature for my cust.I need to upgrade NME-CUE module running 3.1.1 (customer premise) to conform to newly installed C3925 (CME 8.6) (customer premise)So:- Can...
Hi,Could you please put entire Router configure here??And log of "show dial-peer voice sum"Based on your information :The incoming call arrived in port 0/2/1 ( inbound call leg) the it 's routed out port 0/3/3 (outbound call leg)And according to your...
Based on your symtoms, both FXO and IP Phone call leg might be hung up! That why I need your "show voice call status" after the call finished and the guy hangs up his ip phone!
Hi,Based on your debug, after FXO connected to Auto-Attendant (I supposed that since the FXO state moved to Connect without outbound call leg connected), it soon disconnected due to detecting a Release Event from remote side. Of course, FXO had mista...
Hi MohammedAfter the near-end user (using IP Phone) hung up the call and before he initiates a new call, please "show voice call status"Besides,let make a test call (ex: through port 0/3/0) and "debug vpm signal " and "debug vpm port 0/3/0" . After ...
