Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Experts,Really appreciate if anyone could look into this Powertool issue. CU has UCSM configured to use a DNS, however, PowerTool output of the Get-UcsDnsServer command show DNS AdminState as disabled.Even with the DNS servers set to adminstate...
ME3600X (153-3.S4) -Tried configuring ERSPAN on ME3600 switch using new code but it did not work. Configuration guide does not mention anything about the ERSPAN. However, commands are available on the platform.Would like to know if ERSPAN feature is ...
Hello Holger,Counters for (show platform qos dscp-cos counters <int>) commands are cleared upon reload of the switch. I just tested it on my C3850 lab switch.Hope info was helpful. Regards,Sunny
Hi,These counters are cleared upon reload, however, you can clear the queue stats for "sh plat qos queue stats gi1/1/1" command.clear platform qos queue stats gi 1/1/1Please rate this post if it was helpful.ThanksSunny
