we use ISE 2.4 (and 2.6) with Smart licenseAccording to the ISE Admin Guide the "Cisco Smart Software Manager satellite" with Smart Callhome is not supported. But there is an option "transport gateway" which is supported.The newer CSSM satellites (ve...
Hello CommunityI have a problem getting CDP (or LLDP) between ASR9000 (IOS-XR 5.3.4/6.1.4) and Catalyst Switches to work.Case 1: Switch uses default trunk configuration = native VLAN1CDP (or LLDP) works. Both devices see their neighbours. Case 2: The...
Hi All,does anybody know how to clear the Counters for show platform qos dscp-cos counters <int> All other QoS related counters ("show policy-map" etc.) are cleared with "clear counters...", but not this one... Thanks for your ideas! Holger
Hi Colleagues,I'am not sure if this planed setup are valid.We already use 2 ISR G2 (3945) connected via GRE/IPsec. Since we also extend the MPLS Core with this link to the Remote Office (need several VRF's there) MPLS / LDP ist running over the GRE T...
Hello !I found following problem with a LMS2.5.1 installation (and also after upgading to 2.6):RME is not able to backup the Configurations of some of my devices (19 out of more than 100)The backup of VLAN.dat and/or Running-config fails.We have chec...
Hello TimThanks for your great documents, helps a lot to understand MACsec.
I am a little confused, the current documentation (C9300 17.9.) shows two ways to implement a MACsec connection between 2 switches.a) MACsec with fallback key - as described ...
Old bug - but just found one of my switches as affected, C9300 with 16.9.3 Bug Description "known fixed versions" is obvious not correct, my 16.9.3 is listet there as fixed....
same on- C9800 WLC (16.12.1s) - C9300 16.12.2t if your get close to the Communication Deadline, try the following command"license smart renew auth" License Authorization:Status: AUTHORIZED on Mar 19 09:12:46 2020 UTCLast Communication Attempt: FAI...