Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
An IPv6 tunnel (Hurricane Electric) has been in place and working for years. US resident endpoint devices looking to connect to NETFLIX are routed to the IPv6 address where NETFLIX denies access to content since NETFLIX cannot determine if the endpoi...
In this configuration:
FIOS ONT Ethernet ----> 3750 Switch 5 interfaces on VLAN2 two of the 5 interfaces tagged to handle VLAN1 and 2 traffic ----> 1921 router WAN interface connected to one of the VLAN2 3750 interfaces, the two tagged interfaces go...
My network equipment sits in a home office environment. I just replaced a Cisco Catalyst 3750-48G switch with two SG300-28 switches to eliminate the fan noise. The router between the LAN and WAN is a Cisco 1921. What is the optimal way to connect th...
I have a CISCO 1921 Router running IOS Version 15.0(1r)M15. There are two Marantz 7701 pre/pro processors on the LAN side of this router. Marantz makes firmware updates available through the internet. All other network services seem to run without...
When working from home I use an OOMA TELOS VOIP box that is connected to a CISCO 1921 Router running IOS 15.1 on a GIG-E interface. the Router is connected to a FIOS ONT via ethernet and has 30 Mbps download and 25 Mbps upload speeds. There are a n...
Rajeevsh,Thank you for trying to help me. I've read the links you provided and many more before posting my question. The EHWIC configuration guide is nice, but doesn't address the configuration that I am trying to implement. Table 6 of the EHWIC s...
Hello Rajeevsh,
I thought the same commands would work, just as you suggested. That's what I tried and couldn't get to work when I posted for help.
When entering:
interface GigabitEthernet0/0/3
switchport access vlan 2
switchport trunk encapsula...
@ Alexandr: yes the other 50 or so devices, some with client-identifier and others with hardware-address all receive IP addresses correctly from their pools. Only this one instance didn't initially work. Now all seems to be working fine. I have n...
@Alexandr - the client-identifier option was the second setting I tried. It is the second example in my original post.@alain - here's the output from the commands you requested I run:cisco1921#sh ip dhcp conflict IP address Detection method ...
The device that is getting an IP address assigned, but not the address from the pool, is connected to a GIG-E interface on a 3750 switch running IOS 15.0(2)SE2. The switch is connected to a 1921 Router. The DHCP addresses are issued by the router f...
