Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm trying to preprovision some 2248s on a 5548 running 5.0.3.N1.1 and am getting errors while trying to provision slot numbers between 100-108. These are new switches with enough config on them to make them network accessible, no more, no vPC co...
I'm configuring a conditional advertisement configuration to control route advertisement and to provide redundancy. I've configured the system correctly, I can fail the system/fail back with no issues. I know that BGP does not act upon the conditio...
I have a functioning DMVPN environment running with two hubs and approx 95 remote offices using 2621XM VPN Bundles. They have been functioning well for quite a few years now. I am now trying to bring up a new office with a couple of differences, th...
I've included a diagram outlining the scenario I'm dealing with. I have a site, Site A which is a 'hub' site connecting to two other sites, each with their own OSPF processes. I'm currently using redistribution to redistribute desired routes from A...
Pretty simple config Contivity <-> 7200.Phase 1 completes with no issue, all contivity connections fail in the same fashion (see attachment). Traffic Initiated by Contivity - no ACL matches - proper remote and local proxies identified --> end resul...
I believe he (as I) was looking for a way to specify a socks proxy server (v4 and v5 with/without auth). The jump server configuration in the analyzer requires ID/password as well as script commands. What I need is the ability to specify a simple s...
Narayan, have you configured this in the field? I've been attempting to configure this but am running into issues with LACP not meeting the min-links requirement as part of the bundle formation. Between the log messages you'll see this error port-...
Sounds like this may be a cross forest auth issue. Check to see if the two domains are in different forests or the same forest. Here are some URLs that will guide you through the install process. Ensure that they are followed exactly. There is a ...
Stare at things long enough they begin to make sense! The dampening statement is obviously causing the historical entry to be created. I'll be focusing on the dampening aspects to control flapping and to tune the conditional advertisement. Removin...
Issue resolved, not by coming up with a solution to the NAT problem, rather I was able to have the carrier provide us an Internet routeable 29 bit network on the inside of their router.Mike
