Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are having many issues with Windows 8 clients comming onto campus this semeseter. Running 7.4.100.6 (also upgraded one WLC to 7.4.110.0) and many Win 8 devices will not connect, some can't even see SSID's. Then if the bring the notebook to a dif...
Update... had the issue escalated with TAC and PSTS, they found another case with the same issues after upgrading from 3.1 and the issue is in both 3.2 and 3.3, the "fix" is to upgrade to 3.4. I plan on doing that tomorrow, I will update again with ...
I'm having the same issue, and currently have a TAC case open.
I also tried all of the same steps as steiostb1 and thank you for posting the ncs_nb.log, after checking there I was seeing "Not Pushing alert into email queue as emailNotificationFlag...
From the WLC GUI:
on the top navigation select "WLANs", go into each of your WLAN's and click the "Advanced" tab, scroll down about 2/3 the page to the "FlexConnect" section and enable "FlexConnect Local Switching"
This is caused when the building that created in PI has a floor height of 10 feet. PI will not allow you place an AP higher than the floor height. You can go into the building, click the floor and edit the floor area to have a "Floor Height (feet)" t...
I'm being a "me tooer" to Roberts post...Running WLC code 8.0.110.11, PI 2.2 and MSE 8.0.100 and one of my WLC's was at a status of "Inactive" under NMSP and changeing the MSE Assigment as Robert stated brought the WLC back to "Active".
