06-30-2016 07:51 AM - edited 07-05-2021 05:20 AM
Hello,
We have a few FLex Connect Groups setup (not by me) and I have just created one for the first time on our 5508 WLC.
I used the GUI and all the settings look the same as the other Flex Connect groups about from what is under the tab called "WLAN VLAN Mapping"
In there is should show the 2 SSIDs. I have attached an image of a good Flex group and the one I'm doing, how do I add the 2 SSIDs? You can see where I have put the cross that the 2 WLANs are missing.
Thanks
06-30-2016 02:29 PM
Under the WLAN Advanced tab, have you enable "FlexConnect Local Switching" ?
HTH
Rasika
07-01-2016 04:38 AM
Where is this advanced tab?
07-01-2016 06:24 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide